Appendix D. Supported L2TP Attribute/Value Pairs

Table of Contents

D.1. Start-Control-Connection-Request
D.2. Start-Control-Connection-Reply
D.3. Start-Control-Connection-Connected
D.4. Stop-Control-Connection-Notification
D.5. Hello
D.6. Incoming-Call-Request
D.7. Incoming-Call-Reply
D.8. Incoming-Call-Connected
D.9. Outgoing-Call-Request
D.10. Outgoing-Call-Reply
D.11. Outgoing-Call-Connected
D.12. Call-Disconnect-Notify
D.13. WAN-Error-Notify
D.14. Set-Link-Info
D.15. Notes
D.15.1. BT specific notes
D.15.2. IP over LCP

This appendix details the L2TP protocol messages supported, and the attribute/value pairs (AVPs) which are sent and expected for each message.

D.1. Start-Control-Connection-Request

Table D.1. SCCRQ

AVPNo.IncomingOutgoing
Message Type0Value 1Value 1
Protocol Version2Mandatory, value 1 expectedValue 1
Framing Capabilities3IgnoredValue 3
Bearer Capabilities4IgnoredNot sent
Tie Breaker5Ignored as FireBrick only accepts connections for inbound callsNot sent
Firmware Revision6IgnoredFireBrick s/w version string
Host Name7Used to select which incoming L2TP configuration applies.As per config/RADIUS request
Vendor Name8IgnoredFireBrick Ltd
Assigned Tunnel ID9MandatoryMandatory, our tunnel ID
Receive Window Size10Accepted, assumed 4 if not present or less than 4 is specifiedValue 4
Challenge11Accepted if a configured secret is defined, a response is sent in the SCCRPNot sent at present