Command Line Reference

Table of Contents

check access — Check whether an IP address can access/utilise network services provided by the FB2500
check firewall — Checks firewalling rules behaviour.
clear bgp — ** TBC ? **
clear dhcp — Clears one or all of the stored allocations made by the FB2500's DHCP server.
clear l2tp all — ** TBC ? **
clear l2tp session — ** TBC ? **
clear l2tp tunnel — ** TBC ? **
clear pppoe — ** TBC ? **
delete config — Delete a configuration from the Flash memory
delete data — Delete a data item from the Flash memory
delete image — Delete a software image from the Flash memory
ethernet reset — ** TBC ? **
ethernet stall — ** TBC ? **
exit — Logout and end a command-line session.
kill command session — ** TBC ? **
kill session — Kills an active session in the session-table.
login — Login to a command-line session.
logout — Log-out from a command-line session.
panic — Force a system panic.
ping — Ping an IP address.
quit — Logout and end a command-line session.
reboot — Reboots the FB2500.
set boot block — ** TBC ? **
set command screen width — ** TBC ? **
show arp — Prints the ARP table.
show bgp — ** TBC ? **
show bgp nexthop — ** TBC ? **
show bgp peer — ** TBC ? **
show bgp routes — ** TBC ? **
show bgp summary — ** TBC ? **
show boot log — ** TBC ? **
show command sessions — Print a list of command-line sessions.
show dhcp — Print list of IP address allocations made by the FB2500's DHCP server.
show dns — Displays the DNS resolvers that are currently configured for use.
show ethernet counters — Print values of counters maintained by the Ethernet hardware.
show ethernet status — Print current status of the Ethernet ports
show fb105 — Print information about FB105 tunnels.
show flash contents — Print a list of what is currently stored in the internal Flash memory.
show flash log — Print log text stored in the 'Flash log'.
show l2tp — Print overview of L2TP status.
show l2tp session — ** TBC ? **
show l2tp sessions — ** TBC ? **
show l2tp tunnel — ** TBC ? **
show l2tp tunnels — ** TBC ? **
show log — Prints the stored log text for a specified log target.
show memory — Print information about memory usage by the FB2500 application software.
show pppoe — Print information about PPPoE sessions.
show profiles — Print the current state of all the profiles that are defined.
show radius — **TBC ? **
show route — Print information about a specific route.
show routes — Print the list of route destinations from a routing table.
show sessions — Displays the session table.
show status — Print general FB2500 status information.
show subnet — Print information about a specific locally-attached subnet.
show subnets — Print list of locally-attached subnets.
show uptime — Print up-time since last bootup.
show tasks — Prints the list of software tasks running on the FB2500.
show vrrp — Prints VRRP status information.
start command session — ** TBC ? **
traceroute — Runs a classical traceroute procedure.
troff — Prevents log messages sent to the console from being displayed.
tron — Enables log messages sent to the console to be displayed.
uptime — Print up-time since last bootup.

This section provides a reference description for each CLI command. Note that where the Synopsis text spans multiple lines, this is purely for document formatting, and commands should be typed with a newlines only at the very end of the command line.


Chapter 16. Command Line Interface		check access